Всем привет, сегодня менял поршень тормозной стал подтекать немного вылилось тормозной на включено зажигании прокачали с доливкой пока не пошла жидкость тормоза плавные не проваливаются ну стал замечать что после нажатия на тормоз например перед светофором начинает включаться моторчик качать давление если отпустить педаль на месте нажать и отпустить то снова накачаешь где-то секунду и ТД Это нормально или он не должен подкачивать постоянно после каждого нажатия ?
Заранее спасибо!
Педаль тормоза
Модераторы: SNOOPER, Nbf, drcham, Romik, BAlex, DenVer
- Nikolay-ptz
- Сообщения: 68
- Зарегистрирован: 28 май 2018, 19:16
- Двигатель:: П3Did3.2 165 5d 2000 мкпп
- Мой автомобиль(и):: Митсубиси
- Откуда: Петрозаводск
- Благодарил (а): 15 раз
- Поблагодарили: 2 раза
-
- Сообщения: 291
- Зарегистрирован: 07 апр 2016, 08:04
- Двигатель:: 6G74
- Мой автомобиль(и):: Montero 3 Limited 2000
- Откуда: Пермь
- Благодарил (а): 12 раз
- Поблагодарили: 34 раза
Re: Педаль тормоза
1. Depress the brake pedal repeatedly more than 40 times until
the pedal depressing force feels heavy with the ignition
switch at the "LOCK" (OFF) position to release the pressure
of HBB power supply system.
2. Check that the fluid level in the reservoir is at the "MAX" line.
3. Chock the wheels and release the parking brake.
4. Turn the ignition switch to the "ON" position and measure
how long it takes for the pump motor to start, then stop.
Standard value: 20 − 80 seconds
5. After the pump motor stops, start the engine to confirm that
the brake warning light does not come on.
6. Stop the engine and turn the ignition switch to the "ON"
position again.
7. Confirm that the pump motor operates, then stops when the
brake pedal is depressed repeatedly 4 to 5 times.
8. Depress the brake pedal repeatedly 4 to 5 times again to
measure how long it takes for the pump motor to start, then
stop.
Standard value: 2 − 11 seconds
9. Check and confirm the following items 120 seconds or more
after turning ON the ignition switch.
CAUTION
Check and confirm the following items 120 seconds or
more after turning the ignition switch to the "ON" position.
10.Confirm that the buzzer sounds and the brake warning light
illuminates when the brake pedal is fully depressed 15 to 20
times within 10 seconds.
Проверка тормозов из сервис-мануала.
the pedal depressing force feels heavy with the ignition
switch at the "LOCK" (OFF) position to release the pressure
of HBB power supply system.
2. Check that the fluid level in the reservoir is at the "MAX" line.
3. Chock the wheels and release the parking brake.
4. Turn the ignition switch to the "ON" position and measure
how long it takes for the pump motor to start, then stop.
Standard value: 20 − 80 seconds
5. After the pump motor stops, start the engine to confirm that
the brake warning light does not come on.
6. Stop the engine and turn the ignition switch to the "ON"
position again.
7. Confirm that the pump motor operates, then stops when the
brake pedal is depressed repeatedly 4 to 5 times.
8. Depress the brake pedal repeatedly 4 to 5 times again to
measure how long it takes for the pump motor to start, then
stop.
Standard value: 2 − 11 seconds
9. Check and confirm the following items 120 seconds or more
after turning ON the ignition switch.
CAUTION
Check and confirm the following items 120 seconds or
more after turning the ignition switch to the "ON" position.
10.Confirm that the buzzer sounds and the brake warning light
illuminates when the brake pedal is fully depressed 15 to 20
times within 10 seconds.
Проверка тормозов из сервис-мануала.
- DenVer
- Модератор
- Сообщения: 19700
- Зарегистрирован: 29 сен 2009, 17:21
- Двигатель:: бэнзин
- Мой автомобиль(и):: TLC-200
- Откуда: Краснодар
- Благодарил (а): 131 раз
- Поблагодарили: 468 раз
Re: Педаль тормоза
Обычно моторчик подкачивает после трех-четырех нажатий. Вполне возможно что скоро близится замена гидроаккумулятора или в народе "груши"Nikolay-ptz писал(а):Всем привет, сегодня менял поршень тормозной стал подтекать немного вылилось тормозной на включено зажигании прокачали с доливкой пока не пошла жидкость тормоза плавные не проваливаются ну стал замечать что после нажатия на тормоз например перед светофором начинает включаться моторчик качать давление если отпустить педаль на месте нажать и отпустить то снова накачаешь где-то секунду и ТД Это нормально или он не должен подкачивать постоянно после каждого нажатия ?
Заранее спасибо!
- Nikolay-ptz
- Сообщения: 68
- Зарегистрирован: 28 май 2018, 19:16
- Двигатель:: П3Did3.2 165 5d 2000 мкпп
- Мой автомобиль(и):: Митсубиси
- Откуда: Петрозаводск
- Благодарил (а): 15 раз
- Поблагодарили: 2 раза
Re: Педаль тормоза
Окей спасибо
Лето 265 75 16 Hankook Dynapro MT RT03,
Зима 265 70 16 Nexen Winguard WinSpike Шип
Зима 265 70 16 Nexen Winguard WinSpike Шип